Wholesale Automatic Hermetic Door china itself is equipped with an induction probe that can emit an infrared signal or microwave signal. When this signal is reflected by a nearby object, the automatic opening and closing of the induction detector will be realized. When the induction detector detects that someone has entered, the induction detector will collect the signal and generate a pulse signal, and then transmit the pulse signal to the main controller. After judging the main controller, it will notify the motor and monitor the number of motors, In order to inform the motor to force it into low speed operation within a certain period of time. The motor runs forward after a certain running current, and transmits power to the synchronous belt. Then, the power is transmitted to the spreader system through the synchronous belt. Open the door leaf. After opening Wholesale Automatic Hermetic Door china, judge whether the controller is open. If it is necessary to close the door, notify the motor to make a reverse movement and close the door leaf. The following is the troubleshooting of the automatic induction Wholesale Automatic Hermetic Door china introduced.

1. The noise of Wholesale Automatic Hermetic Door china during operation is too loud. The noise generated by the friction between the movable door leaf and the fixed door or the wall during operation can be adjusted properly. The traveling wheel of the lifting appliance of Wholesale Automatic Hermetic Door china is worn due to the long service time. It only needs to be removed, cleaned and lubricated. Some fixed parts are loose and only need to be reinforced. The box and guide rail are not installed properly, It resonates with the gypsum board of the ceiling. If Wholesale Automatic Hermetic Door china clip or rail fixing the door panel is damaged, you need to remove the box to see if there is any damage inside. If there is, you need to replace it.

2. When Wholesale Automatic Hermetic Door china is opened and closed without being controlled, if there is a radar, it may be that moving objects often pass through the range of the radar sensor or the door itself is illuminated, and only the range or sensitivity of the radar need to be adjusted. In another case, the safety photoelectric device may be blocked by an object, and the safety photoelectric device needs to be checked.

3. If the Automatic Hermetic Door china body runs too slowly, you can manually adjust the speed in the controller. If the speed is still slow after adjustment, the motor may have low power and cannot be pulled. At this time, you need to consider changing the motor with higher driving force. Loose or falling slings may also cause this problem.

4. Safety light failure

Solution: Remove the safety light wiring, Wholesale Automatic Hermetic Door china can operate normally, update the safety light or electric controller, and eliminate other parts with suspected problems.

5. Sensor failure

Solution: Remove the inductive wiring, press the "test key" and Wholesale Automatic Hermetic Door china can operate normally. At the same time, update the electric controller after eliminating other components with problems.

6. Electric controller failure

Solution: Remove the induction wiring, and check the line connected to the motor after Wholesale Automatic Hermetic Door china can not operate normally after pressing the "test key" for many times. At the same time, update the electronic controller after eliminating other components with problems.

7. Motor failure

Solution: Remove the induction wiring, and check the line connected to the motor after Wholesale Automatic Hermetic Door china can not operate normally after pressing the "test key" for many times. Renew the motor and eliminate other parts with problems.