The customized telescopic door is mainly composed of door body, driver and control system. The door body of the customized telescopic door is made of excellent aluminum alloy and ordinary square pipe, hinged by the principle of parallelogram, with flexible expansion and large stroke. The driver of the customized telescopic door is driven by a special motor, the worm gear is decelerated, and is equipped with a manual clutch. It can be opened and closed manually in case of power failure. The control system of the customized telescopic door is equipped with a control board, a button switch, and a wireless remote control device according to the needs of users. Now I share with you how to install trackless telescopic door Of course, it can also be used for rail installation The main reason is that the universality of trackless telescopic door is better than that of rail telescopic door Therefore, the installation method of trackless is introduced here.

 Introduction steps of customized telescopic door installation
1. Fix the door body: put the door body into the track, and fix the bottom support at the tail with special fixing card and anchor expansion screw.
2. Limit switch: embed the limit device according to the opening and closing positions of the set door body
3. Fixed control box: the control box can be installed in the head box or moved indoors within 10 meters from the host.
4. Connecting line: connect the corresponding lines in strict accordance with the wiring diagram (it is strictly prohibited to connect under the power on state). The wiring shall be firm, there shall be no short circuit between terminals, and check whether the line is correct.
Installation and commissioning of customized telescopic door
1. First, manually push and pull the door body to check whether the door body operates normally. Only when it is determined that the door body operates normally can the power be connected.
2. When the power is turned on, the power indicator of the control box will be on. Press the "on" button, the "on" indicator will be on, and the door will automatically open and stop at the set limit. Press the "off" button, the "off" indicator light will be on, and the door will close automatically and stop automatically at the set limit.
3. In case of inaccurate door operation limit during commissioning, the height of limit switch can be adjusted.
4. After more than 5 times of debugging and operation, it can be put into use only if everything is normal.